Seminole Heights has some of the best old houses in Tampa: craftsman bungalows from the 1910s and 1920s, raised floors, original wood windows, and big oaks shading the yard. It also has some of the hardest-working heating systems in Hillsborough County. Most of these homes were built long before central air and heat, so the system you have now was added later, often squeezed into a crawlspace, a tight attic, or a closet that was never meant for it. With a cold front headed our way, now is the time to make sure your heat is actually ready, not the first chilly night you flip the thermostat to HEAT.
Here’s what a licensed tech at Nolan Air looks for in older Seminole Heights homes, and what you can check yourself this week. For everything we do in the neighborhood, see our Seminole Heights HVAC service page.
Why older bungalows are tougher to heat
A newer block home holds heat pretty well. A wood-frame bungalow on piers is a different story. Cold air moves under the raised floor, original windows leak a little around the sashes, and attics in many of these homes have less insulation than a modern build. None of that is a problem most of the year in Tampa. But when the temperature drops into the 40s overnight, your heat pump or furnace has to make up for every one of those losses, and any weak spot in the system shows up fast.
The other common issue is ductwork. Retrofitted ducts in Seminole Heights often run under the house through the crawlspace. If a run has come loose, gotten crushed, or been chewed on, you can be paying to heat the dirt under your floor instead of your living room.
Five checks to do before the cold front
- Test heat mode on a mild day. Set the thermostat to HEAT, fan on AUTO, and raise the setpoint a few degrees above room temperature. Within a few minutes, the air from your vents should feel clearly warm. Finding out now beats finding out at 6 a.m. on the coldest morning of the year.
- Walk the house and feel every register. If the front bedroom or the back addition barely gets airflow while the rest of the house is fine, that points to a duct problem, not a weak heater.
- Change the filter. Older return setups are often undersized to begin with. A dirty filter on top of that starves the system of air and makes heat strips and heat exchangers run hotter than they should.
- Clear the outdoor unit. Oak leaves and Spanish moss pile up fast in this neighborhood. A heat pump needs open airflow around the outdoor coil to pull heat in winter, so give it a couple of feet of clearance.
- Pay attention to the first smell. A light burning-dust smell for the first few minutes is normal, since dust burns off heat strips or a furnace after months of sitting. If the smell sticks around, smells electrical or like hot plastic, or a breaker trips, shut the system off and call us.
If you have gas heat
Some older Tampa homes still have a gas furnace. If yours does, make sure you have a working carbon monoxide detector near the bedrooms before you start running heat, and don’t ignore a yellow, flickering burner flame, soot around the furnace, or a pilot that keeps going out. Those are reasons to have a licensed tech look at it before the cold front, not after.
What a pre-winter heating check covers
When a Nolan Air tech comes out for a heating tune-up, we typically:
- Run the system in heat mode and measure the temperature rise at the supply vents.
- On heat pumps, confirm the reversing valve shifts and the defrost cycle works, and check refrigerant performance.
- Check amp draw on heat strips and make sure the sequencers bring them on and off in stages.
- On gas furnaces, inspect the burners, flame sensor, ignition, and venting, and look over the heat exchanger.
- Tighten and inspect electrical connections, capacitors, and contactors.
- Take a look at accessible ductwork in the crawlspace or attic for disconnected or crushed runs that are costing you heat.
- Go over your thermostat settings, including emergency heat and auxiliary heat, so you know what’s normal.
If we find a problem, you’ll get a straight explanation and options before any work starts. Learn more about heating repair and service in Seminole Heights, or if you run a heat pump, our heat pump repair in Seminole Heights page covers the common failures we see in older systems.
When it’s more than a tune-up
If your system is pushing 15 years old, the heat strips carry most of the load every winter, or some rooms never warm up no matter what you do, a tune-up will tell you that. Sometimes the fix is a single part. Sometimes it’s a duct repair under the house. And sometimes it’s an honest conversation about whether a right-sized system would serve an older home better. We’ll tell you which one it is.
Serving Tampa’s older neighborhoods and beyond
We see the same patterns in historic homes across the city, from Seminole Heights down to South Tampa, and in newer communities further out like Sun City Center. Older home or new build, the advice is the same: test your heat before you need it.
Get ahead of the cold
The best time to find a heating problem is on a 75-degree afternoon, not a 42-degree morning. If it’s been more than a year since anyone looked at your system, get it checked now while the weather is mild and the schedule is open.
Call Nolan Air at (727) 353-9293, Monday through Friday, 8am to 7pm, or schedule online any time. Veteran-owned and locally operated, with licensed techs who know Tampa homes. Visit NolanAir.com to learn more.