South Tampa homes take a beating most people never think about in November. Hyde Park bungalows, Palma Ceia ranches, Bayshore condos and the new two-story builds going up off Westshore all share one thing: a heat pump that has spent eight straight months in cooling mode, breathing salty air off Hillsborough Bay and Old Tampa Bay. Then a cold front rolls through, you flip the thermostat to HEAT for the first time since February, and you find out whether that system is actually ready. With cooler nights on the way, now is the time to get your heat pump tuned up, before the first cold snap instead of during it.
Here’s what a licensed tech at Nolan Air checks on South Tampa heat pumps before winter, and a few things you can look at yourself this weekend. For everything we do in the neighborhood, see our South Tampa HVAC service page.
Why South Tampa heat pumps need a pre-winter look
Most South Tampa homes heat with a heat pump, not a gas furnace. A heat pump is just your AC running in reverse: the reversing valve flips, the outdoor coil pulls heat out of the air, and backup heat strips in the air handler kick in when it can’t keep up. That reversing valve and those heat strips may not have run once since last winter. If something stuck, burned out or corroded over the summer, the first chilly night is when you’ll find out.
Being this close to the water adds a second problem. Salt air eats at outdoor coil fins, electrical connections and the contactor inside the condenser. A lot of South Tampa homes also have outdoor units raised on stands or platforms because of flood zones, which keeps them out of storm surge but leaves them more exposed to wind and spray. Corrosion that was “fine” in July can turn into a failed start on a 45-degree morning.
What a heat pump tune-up should cover
A real tune-up is more than a filter swap and a quick look. On a pre-winter visit, our techs:
- Run the system in heat mode and confirm the reversing valve switches cleanly and the supply air is actually warm.
- Test the backup heat strips in the air handler, check amp draw, and make sure the sequencers and limit switches work. Weak strips are the number-one reason a house can’t catch up on a cold morning.
- Check the defrost cycle. When it gets cold and damp, the outdoor coil frosts over and the system has to defrost itself. A bad defrost board or sensor can leave the unit iced up.
- Inspect electrical connections and the contactor for salt corrosion, pitting and loose terminals, and test the capacitor.
- Check refrigerant pressures in heat mode. A system that was barely keeping up in summer may be low on charge, and it’ll show up even more in heating.
- Clean and inspect the outdoor coil, rinse salt and pollen off, and straighten damaged fins where we can.
- Verify thermostat settings, including how and when auxiliary and emergency heat come on.
If we find a failing part, we’ll show you what it is and what it does before anything gets replaced. If you need it, here’s more on heat pump repair in South Tampa, and our full South Tampa heating services page covers both heat pumps and furnaces.
Five things you can check yourself this weekend
- Do a test run now. Pick a cool evening, switch to HEAT, set it a few degrees above room temperature and let it run 15 minutes. Warm air at the vents is a good sign. Cool or room-temperature air means it’s time to call.
- Expect a little burning-dust smell, but only briefly. Heat strips collect dust over the summer and burn it off on the first run. That smell should fade within about 30 minutes. If it lingers, or it smells like hot plastic or electrical burning, shut the system off and call us.
- Change the filter. A clogged filter makes heat strips run hot and can trip the high-limit switch, which shuts the heat off on you.
- Clear around the outdoor unit. Rake away oak leaves, palm fronds and mulch, and keep at least two feet of clearance. If your unit sits on a raised stand, make sure it’s level and secure after storm season.
- Know what “EM HEAT” means. Emergency heat runs only the heat strips and skips the heat pump. It works, but it’s expensive to run. Don’t leave it on unless your heat pump has actually failed and you’re waiting on a repair.
When to call instead of waiting
Call us if the outdoor unit isn’t running while the indoor fan blows, if the outdoor coil stays caked in ice for more than an hour or so, if the breaker for the air handler keeps tripping, or if the house just can’t get above the mid-60s on a cool night. Those are all easier and cheaper to fix on a weekday before the front arrives than on the first cold morning when everyone in Tampa is calling at once.
Neighbors across Hillsborough County
We do the same pre-winter heat pump checks all over the county, from the older homes in Seminole Heights down to the communities in Sun City Center and Sun City.
Get your heat checked before the cold front
Don’t wait for the first 40-degree morning to find out your heat strips are dead. Call Nolan Air at (727) 353-9293, Monday through Friday, 8am to 7pm, or schedule online and a licensed tech will get your South Tampa heat pump ready for winter. Learn more at NolanAir.com.