A cold front is on its way to Tampa Bay this week, and in Fish Hawk that usually means one thing: the heat gets switched on for the first time since last winter, and a lot of homeowners find out the upstairs system and the downstairs system are not in the same shape. If your house has two thermostats, you have two heating systems to check. The good news is you still have a few mild days to do it.
If you live in Apollo Beach, our Apollo Beach HVAC service area page lists the services we offer there and the neighborhoods we cover.
Our licensed techs at Nolan Air spend a lot of time in FishHawk Ranch and the neighborhoods off Boyette and Lithia Pinecrest. Most of the homes here were built from the late 1990s on, many are two stories, and the typical setup is a heat pump with electric heat strips, often split into two systems: one air handler in a garage or closet for the first floor, and a second one up in the attic for the bedrooms. That layout works well, but it means twice the parts that can sit idle all summer and fail on the first cold morning. If you want a pro to look at yours, start with our Fish Hawk HVAC service page.
Test each system on its own
Do not just turn on the downstairs heat and call it good. Go to each thermostat, switch it from Cool to Heat, and set it about three degrees above the current room temperature. Give each one ten minutes. You want clearly warm air at the supply vents on that floor and the matching outdoor unit running. If you are not sure which outdoor unit belongs to which floor, test one thermostat at a time and walk outside to see which condenser starts.
If one floor heats and the other blows cool or room-temperature air, you have found your problem before the front gets here, which is exactly when you want to find it.
Why the upstairs system is usually the one that struggles
Attic air handlers have a rough life in Florida. All summer they sit in an attic that can run well past 120 degrees, and that heat is hard on wiring, capacitors, and the heat strip controls. A few things we check first on upstairs units in Fish Hawk:
- Heat strip sequencers and limit switches. These control the backup electric heat. After a long hot summer, a sequencer can fail or a limit switch can be tripped, and you will not know until the heat pump alone cannot keep the bedrooms warm.
- Condensate drain and safety switch. Many attic units have a float switch that shuts the system down if the drain backs up. A clog left over from summer can keep the heat from running at all.
- Filter access. Upstairs return filters are easy to forget. A clogged filter makes heat strips run hot and trip their safeties.
Understand Aux Heat and Emergency Heat
Your thermostat probably shows an Aux Heat indicator, and it may have an Emergency Heat setting. Aux Heat means the heat strips are helping the heat pump, which is normal on a cold morning or when you bump the temperature up a lot at once. If Aux Heat is on almost all the time when it is only in the 50s or 60s outside, the heat pump is not doing its share and is worth a look.
Emergency Heat turns the heat pump off and runs only the strips. It is useful if an outdoor unit is clearly broken, but it costs a lot more to run, so use it as a short bridge until a tech can come out. One more tip: big setbacks overnight followed by a jump in the morning tend to call for strip heat. Small, steady changes are easier on your power bill.
That smell the first time the heat runs
A light burning-dust smell for the first few minutes is normal. Dust settles on the heat strips over the summer and burns off. If the smell hangs around for more than an hour, smells like hot plastic or wiring, or you see any smoke, turn the system off at the thermostat and call us.
What a heating tune-up covers
A pre-winter heat pump tune-up is not just a filter swap. On each system our techs check the reversing valve that switches the heat pump into heating, the refrigerant charge, the defrost controls on the outdoor unit, the heat strips and their controls, the capacitor and contactor, the blower, and the electrical connections. In a two-system home we do both units in the same visit so you know the whole house is ready. You can read more on our Fish Hawk heating page, and if a test already failed, our Fish Hawk heat pump repair team can track it down.
Quick checks before you call
- Replace the filters for both systems.
- Check the breakers for each air handler and each outdoor unit. Heat strips often have their own breaker.
- Clear leaves, mulch, and lawn clippings at least two feet back from both condensers.
- Make sure upstairs and downstairs vents and returns are not blocked by furniture or rugs.
- Swap thermostat batteries if your models use them.
We also take care of homeowners up in Keystone, plus closer to downtown on Davis Islands and Harbour Island.
Get ahead of the cold front
Schedules fill up fast in the days right before a front, so the best time to find a weak heat pump is now, while the house is still comfortable. Call Nolan Air at (727) 353-9293 Monday through Friday, 8am to 7pm, or book online and we will get a licensed tech to your Fish Hawk home before the cold sets in. Learn more at NolanAir.com.