For immediate service, please call (727) 353-9293 or email service@nolanair.com | Mon-Fri 8am-7pm

(727) 353-9293 · Mon–Fri 8am–7pm

Pebble Creek Thermostat Settings for Heat Season: Set It Right Before the Cold Front

Pebble Creek homeowners, here’s something we see every winter: the heating system is fine, but the thermostat is set up like it’s still July. The first cold morning comes, the house takes forever to warm up, the electric bill jumps, and the call comes in. With a cold front heading into Tampa Bay this week, take ten minutes now to set your thermostat up for heat season and run a quick heat test before you actually need it.

Most homes in Pebble Creek, from the streets around the golf course to the neighborhoods off Bruce B. Downs and Cross Creek Boulevard, heat with an electric heat pump and backup heat strips in the air handler. That setup works great in our mild winters, but it’s picky about thermostat settings. Our licensed techs at Nolan Air handle heating calls all over New Tampa and north Hillsborough. You can see what we do locally on our Pebble Creek HVAC service page.

Step 1: Switch to HEAT and run a test now

Don’t wait for the first 45-degree morning to find out something’s wrong. On a mild afternoon:

  • Switch the thermostat from COOL to HEAT.
  • Set it 3 to 4 degrees above the current room temperature.
  • Give it 10 to 15 minutes. You should feel warm air at the vents and hear the outdoor unit running.
  • Expect a light burning-dust smell for the first few minutes. That’s dust cooking off the heat strips after months of sitting. If it hangs around longer than an hour, or smells like melting plastic or wires, shut the system off and call us.

If the outdoor unit won’t start, the air coming out is cool, or the thermostat screen is blank, now is the time to find out, not on the coldest night of the week.

Step 2: Keep setbacks small with a heat pump

A lot of folks drop the heat way down at night or while they’re at work, then crank it back up. With a gas furnace, that can save money. With a heat pump, a big jump often does the opposite. When you ask for a 6- or 8-degree recovery all at once, many thermostats bring on the heat strips to catch up, and strips are the most expensive way to heat your home.

A better approach for most Pebble Creek homes:

  • Pick a comfortable setting, usually somewhere in the upper 60s to low 70s, and leave it.
  • If you use a schedule, keep the setback to 2 or 3 degrees.
  • If you have a smart thermostat, look for a heat pump or “smart recovery” setting that warms the house slowly instead of calling for backup heat.

Step 3: Know your AUX and EM HEAT settings

If your thermostat shows AUX or AUX HEAT for a few minutes on a cold morning or during defrost, that’s normal. It’s the heat strips helping out. EM HEAT (emergency heat) is different. It shuts off the heat pump and runs on strips alone. It’s meant for when the outdoor unit is broken or iced over, not for everyday use. We regularly find thermostats that got bumped into EM HEAT and stayed there all winter. If your bills look high and you see EM HEAT on the screen, switch it back to regular HEAT.

If you see AUX running nonstop, even on mild days, that’s a sign the heat pump isn’t pulling its weight. Low refrigerant, a failing outdoor fan, or a bad reversing valve can all cause it, and that’s a job for heat pump repair in Pebble Creek.

Step 4: Fan on AUTO, fresh batteries, clean filter

  • Fan on AUTO, not ON. With the fan on ON, it keeps blowing between heating cycles, and that air can feel drafty and cool coming out of the vents.
  • Swap the batteries if your thermostat uses them. Weak batteries cause blank screens and random shutoffs, usually at the worst time.
  • Change the air filter. A clogged filter after a long summer chokes airflow, makes the strips run hotter, and can trip the high-limit safety.

Step 5: Is it the thermostat or the system?

Sometimes the thermostat itself is the problem. Older non-programmable models, units that were wired for cooling only, or a thermostat that reads several degrees off from the actual room temperature can all cause short cycling, cold spots, and strips running when they don’t need to. If your thermostat is more than 10 years old or was never set up for a heat pump, upgrading it can make a real difference. We handle thermostat installation in Pebble Creek and set the heat pump controls correctly so backup heat only runs when it should.

When to call a licensed tech

Call us if you notice any of these during your heat test:

  • No warm air after 15 minutes in HEAT mode
  • The outdoor unit doesn’t run, or it hums without the fan turning
  • A burning smell that doesn’t fade, or any electrical smell
  • The breaker for the air handler or outdoor unit keeps tripping
  • AUX heat running constantly on mild days

A heating tune-up in Pebble Creek covers the parts you can’t see: heat strip connections, sequencers, refrigerant charge, the reversing valve, the defrost controls, and the electrical connections that wear out over the summer.

Get ahead of the cold front

We’re booking heating checks across north Hillsborough this week, including in Northdale, out east in Plant City, and down in Riverview. When the first cold night hits, everyone turns the heat on at once, so it pays to get on the schedule while the weather is still mild.

Call Nolan Air at (727) 353-9293, Monday through Friday, 8am to 7pm, or schedule online anytime at NolanAir.com. Get your heater checked now, before the cold front gets here.

14 December 2024

5 Signs Your AC Needs Repair in Tampa Bay

Living in Tampa Bay means relying on your air conditioner nearly year-round. But how do you know when your AC system needs more than just a filter change? Spotting early warning signs can save you from more costly repairs down the line. Homeowners often overlook subtle issues until they grow into major problems.
20 January 2025

Why Preventative AC Maintenance Matters in Florida

In Florida, skipping your annual AC maintenance can lead to unexpected breakdowns during the hottest months. Your system runs longer and harder in our climate, which makes preventive care a smart investment for every homeowner. A little maintenance can go a long way in reducing repair costs.

Join our newsletters!

By submitting you agree on our Privacy Policy