A cold front is headed for Tampa Bay this week, and on Harbour Island the heat has probably not been touched since last winter. Most homes here are condos and townhomes, and most of them heat with a heat pump or electric heat strips tucked into a hall closet or a small utility room. Those compact setups work fine, but they get ignored all year, and the first chilly night is when a weak one shows up. You still have a few mild days to test yours, so let’s use them.
If you live in New Tampa, our New Tampa HVAC service area page lists the services we offer there and the neighborhoods we cover.
Our licensed techs at Nolan Air work in homes all over downtown Tampa, and Harbour Island has its own quirks: tight closets, outdoor units on balconies, roofs, or shared pads, and plenty of salt air coming off the channel and Hillsborough Bay. If you want a pro to look at your system, start with our Harbour Island HVAC service page.
Run a ten-minute heat test today
Switch the thermostat from Cool to Heat and set it about three degrees above the room temperature. Within a few minutes you should feel clearly warm air at the vents, not just moving air. If you have a split heat pump, the outdoor unit should be running too. Let it go for ten minutes and walk the whole unit, including the bedroom farthest from the air handler. If the air stays lukewarm, or the system starts and stops every minute or two, you’ve found a problem while you still have time to fix it.
Know what kind of system you have
Harbour Island buildings are not all set up the same way, and it matters for who you call and what gets checked.
- Split heat pump. An air handler inside the unit and a condenser outside on a balcony, rooftop, or ground pad. This is the most common setup we see in townhomes.
- Air handler with heat strips only. Some units cool with one system and heat only with electric strips in the air handler. These are simple, but a failed strip or a tripped limit switch means no heat at all.
- Building-connected systems. Some condo towers use equipment tied into a shared building system. If that is your building, check with management about what the association maintains and what is your responsibility before you book service.
Not sure which one you have? Snap a photo of the label on the air handler and the outdoor unit and our team can tell you when you call.
Closet air handlers need breathing room
In condos the air handler often shares a closet with a water heater, a vacuum, and a few boxes of holiday decorations. That clutter blocks the return, starves the system of air, and makes heat strips run hot until a safety switch shuts them down. Clear at least a couple of feet in front of the unit, make sure the closet door louvers are not covered, and swap the filter. A clogged filter is the number one reason we find heat strips tripping on the first cold night.
Salt air and the outdoor unit
Being on the water is great until you look at a coil that has been sitting in salt spray for a few years. Corrosion on the outdoor coil and electrical connections hurts heating as much as cooling, because a heat pump pulls heat from outdoor air through that same coil. Rinse the outdoor coil gently with a garden hose (no pressure washer), and keep patio furniture, planters, and storage at least two feet away. If you see heavy white or green corrosion on the copper or the wiring, have it looked at before the front arrives.
Aux heat, emergency heat, and that first-run smell
When the thermostat shows Aux Heat, the electric strips are helping the heat pump. That is normal on a cold morning. If Aux Heat runs nearly all the time when it is in the 50s or 60s outside, the heat pump is not pulling its weight. Emergency Heat shuts the heat pump off and runs only the strips. Use it as a short-term bridge if the outdoor unit is clearly broken, because it costs a lot more to run.
A light burning-dust smell for the first few minutes is normal as summer dust burns off the strips. If it lasts more than an hour, smells like hot plastic or wiring, or you see smoke, turn the system off at the thermostat and call us.
What our heating tune-up covers
A pre-winter heat pump check is more than a filter. Our techs test the reversing valve that switches the system into heat mode, the defrost controls, the refrigerant charge, the heat strips and their sequencers and limit switches, the capacitor and contactor, the blower, the condensate drain and float switch, and the electrical connections, with extra attention to corrosion on coastal units. Learn more on our Harbour Island heating page, or if your test already failed, our Harbour Island heat pump repair team can track it down.
Quick checks before you call
- Replace the return filter.
- Check the breakers for the air handler and the outdoor unit. Heat strips often have their own breaker.
- Replace thermostat batteries if yours uses them.
- Clear the air handler closet and the space around the outdoor unit.
- Open supply vents in every room, including guest rooms you keep closed.
We also help homeowners out in Fish Hawk, up north in Lutz, and over in Keystone get their heat ready for the season.
Get your heat checked before the front
The calendar fills up fast right before the first real cold snap, so the best time to catch a weak heat pump is now, while your place is still comfortable. Call Nolan Air at (727) 353-9293 Monday through Friday, 8am to 7pm, or book online, and we’ll get a licensed tech to your Harbour Island home before the cold sets in. Learn more at NolanAir.com.